MOTOR BOWMOTOR 3

Description

Huge 5” diameter x 10” long (125 x 252mm) housing complete with adaptor to not only help the motor to run cooler, but also to contain a massive armature and copper welded commutator.
8 huge brushes, each with twin insulated flexible copper wires located in solid brass brush holders mounted in a cast aluminium frame to take away some of the heat and provide a bearing block at the back end.
4 large field coils surround the armature all connected with heavy copper bus bars.
All in all a motor and a half!
The nominal speed is 4,000 rpm, similar to a Bow ‘1’ but with a huge amount of torque and rated at an amazing 9HP. However in use these are much faster than both the Bow ‘1’s & ‘2’s.
A challenge truck using one of these on either a single top 8274 or a twin top .
To get the best out of these motors you will need a very good battery setup, ideally 3 big 12 volt batteries in parallel driven by a big alternator– a 150 amp one would be brilliant. The supplied adaptor allows these Bow ‘3’s to be bolted onto the Bow ‘1’ & ‘2’ etc fixing holes on the winch. Each motor weighs 12kg.

Delivery varies between 2 days and 3 weeks 

For any question, please contact OffRoad Projects